aspectPRO navigation button

Same-Day Shipping: In-Stock Orders Placed Before 4pm CST

RGBCCT Handheld Remote Installation Guide

Overview

This guide provides information on how to install and operate your RGBCCT handheld remote system, including required tools and components, safe installation practices, wiring and pairing steps, and basic programming for custom lighting effects. It’s designed to help you confidently set up and control your RGBCCT LED strip lights while ensuring proper performance and safety. If you need additional support at any point, call 888.503.1317 or email support@aspectled.com.


Tools You’ll Need
  • Small screwdriver (for wiring the receiver)
  • Wire strippers
  • 3x AAA batteries (for remote)
Products You’ll Need
Before You Begin

Please review the following safety protocol before starting any work. Remember S.A.F.E.T.Y..

S: Shut off power.

A: Ask a licensed electrician if needed.

F: Follow NEC guidelines.

E: Equip yourself with proper PPE.

T: Treat the wires as live.

Y: You are responsible.

Important Handling Information:

  • Do not expose the device to moisture.
  • The remote operates in temperatures between 32-104°F.
  • The device contains AAA batteries that shall be stored and disposed properly.
  • One receiver can be paired with a maximum of 8 different remote controls.

Function Introduction

RGBCCT Handheld Remote Function Introduction Diagram
Installation Steps

Wiring and Preparation

  • Install 3x AAA batteries into the remote.
  • Wire the RF receiver according to the wiring diagram provided with the receiver.

Pairing the Remote to the Receiver

  • Click the ON/OFF button to activate the remote.
  • Power off and power on the receiver.
  • Choose and click a zone number on the remote.
  • Touch the color wheel.
  • The LED lights connected with the RF receiver will flicker once.
  • This signifies that the receiver is paired with the zone successfully.
How to pair the remote with RF receiver (Method 1)

Programming a Custom Running Mode

  • Click the ON/OFF button to activate the remote.
  • Choose and click one or multiple paired zone numbers.
  • Click the "P" button.
  • The LED lights connected with the receiver will flash once.
  • Touch the color wheel to select 2 to 5 colors.
  • Click the "P" button again to confirm the selected colors.
  • The LED lights connected with the receiver will flash once again to confirm.
  • Press the play button to run the program.
Custom Program for RGBCCT Handheld Remote
Wiring Diagrams

Multiple Receiver Layout Options:

  • Option 1: Have all the receivers in the same zone, like Zone 1.

Receivers in Same Zone Diagram

  • Option 2: Have each receiver in a different zone, like Zone 1, 2, 3, or 4.

Receivers in Different Zones

Troubleshooting/FAQ

How do I stop a running mode on a single color LED light caused by interference?

  • When pairing a single color LED light to a single color remote, it might be interfered with by nearby RGBW senders.
  • This interference might force the single color light into a running mode.
  • To fix this, pair this RGBCCT remote to the receiver.
How to pair the remote with RF receiver (Method 2)
  • Touch the color wheel to stop the running mode.
  • Delete the pairing and pair the receiver to the single color remote again.
  • The light can then be controlled normally by the single color remote.